Victron Energy Blue Smart IP67 Charger

Blue SmartIP67 Charger

Ready for Bluetooth Smart
The Blue Smart IP67 charger is the wireless solution for monitoring voltage and current, adjusting settings and updating the charger when new features are available. The functionality of the IP67 charger is further expanded with Bluetooth and is therefore roughly equivalent to that of our IP22 and IP65 chargers.

Fully encased:
waterproof, shockproof and fire retardant.
Water, oil or dirt cannot damage the Blue Smart IP67 charger. The housing is made of cast aluminum and the electronics are coated with resin.

Highest charging efficiency ever!
Setting a new industry standard: With an efficiency of at least 92% or more, these chargers produce three to four times less heat. Additionally, after the battery is fully charged, power consumption drops to less than one watt, which is about five to ten times better than the industry standard.

Adaptive 5-stage charging algorithm: "Bulk" (constant current phase) - "Absorption" (constant voltage phase) - "Recondition" (regeneration phase), - "Float" (charge maintenance voltage phase) - "Storage" (storage mode)
The Blue Smart charger is characterized by its microprocessor-controlled, “adaptive” battery management. “Adaptive” means that the charging process is automatically adapted to the type of battery use.

Storage mode: Less maintenance and aging when the battery is idle.
Storage mode is activated whenever no discharge has occurred within 24 hours. In storage mode, the float charge voltage is then reduced to 2.2 V/cell (13.2 V for a 24 V battery) to minimize gassing and corrosion of the positive plates. Once a week, the voltage is increased to the level of the gassing voltage. This creates a type of equalization charge that prevents electrolyte stratification and sulfation - the two main causes of premature battery failure.

Also charges lithium-ion batteries
Lithium-ion batteries are charged using a simple constant current phase, constant voltage phase, float voltage phase algorithm.

Recovery function for fully discharged batteries
Will initiate charging even if the battery has been discharged to zero volts. Reconnects a fully discharged lithium-ion battery with built-in disconnect function.

Overheating protection
Can be used in a hot environment such as an engine room. The output current will be reduced when the temperature rises up to 60°C, but the charger will not fail.

Two LEDs for status display
Yellow LED: Constant charge phase (blinking quickly); Constant voltage phase (blinking slowly); Float voltage phase (lit); Storage voltage phase (off). Green LED: On